My Garage Add a vehicle

Pick your vehicle in the Shop By Vehicle bar below and every page shows the parts that fit it.

Cart
Reset

Pertronix Dist British A+ 4 cyl cast, I3 vac

Part # D7174218SKU PERD7174218

Universal fit

Specifications
BrandPertronix
Part typeDistributor
Adjustable CollarNo
Advance TypeVacuum and mechanical
Cap ColorBlack
Cap Terminal GenderFemale
Clamp Hardware IncludedNo
Clamp IncludedNo
Coil Wire IncludedNo
Computer Controlled CompatibleNo
Connector TypeUnsealed
Distributor Cap IncludedYes
Distributor Gear IncludedYes
EmissionFullDES1 - This product has been granted a California Air Resources Board (CARB) Executive Order (EO Number) Exemption. It is 50 State Legal when installed on the Specified vehicle per the Manufacturer’s Current Application Guide, the CARB EO, and Installation Instructions.
Gear MaterialSteel
Grade TypePerformance
Housing ColorNatural
Housing FinishNatural
Housing MaterialAluminum
Ignition Box RequiredNo
Ignition Coil IncludedNo
Ignition Module IncludedYes
Ignition Rotor IncludedYes
Marine ApprovedNo
Mechanical Tach Drive ProvisionNo
QuantitySold individually.
Shaft ColorNatural
Shaft Diameter.490 in
Shaft MaterialSteel
Trigger TypeHall Effect
UPC / GTIN00694342541194
  • Available for 12-volt negative and positive ground systems.
  • All new lightweight cast aluminum housings.
  • Balanced rotor with overmolded brass contact.
  • Tailored advance curve for optimal performance and drivability.
  • High dielectric strength cap with brass terminals.
  • Ignitor III multi-spark rev limiting modules.
  • Integrated Ignitor electronic ignition delivers twice the voltage to the spark plugs, increasing horsepower, fuel economy, and spark plug life.
  • Not legal for sale or use on pollution controlled motor vehicles.
  • Peak current level is reached just prior to spark for maximum energy without the heat build-up, increasing coil and module life.
  • Rotating cobalt magnets trigger a Hall Effect integrated circuit which enables precise timing.
  • Top or side exit caps available.

Description

Replace your worn out Lucas 23D, 25D or 45D distributor with a distributor that will deliver the performance you demand. Our Flame-Thrower performance distributors use all new castings modeled after the original Lucas 45D distributor. Each distributor is then precision machined for an exact fit. Four cylinder applications are available with top or our new side exit caps.

FEATURES